Contents
1
1 Preparing for Use
Installing the Signal Generator 1-2
Checking the Shipment 1-2
Installing Front Handles and Rack Mount Flanges 1-4
Meeting Electrical and Environmental Requirements 1-5
Adjusting the Display Contrast 1-6
Selecting Inverse Video 1-6
Adjusting the Screen Saver 1-6
Selecting the Signal Generator’s HP-IB Address 1-7
Selecting the Signal Generator’s Programming Language 1-8
Verifying Signal Generator Operation 1-9
Operator’s Check 1-9
2 Using Functions
Setting Frequency and Power Levels 2-2
To Set the RF Frequency 2-2
To Set a Frequency Reference and a Frequency Offset 2-3
To Set the RF Output Power Level 2-4
To Set an Amplitude Reference and an Amplitude Offset 2-4
Setting Up Internally-Generated Amplitude Modulation 2-6
Setting the Carrier Frequency 2-6
Setting the Power Level 2-6
Setting the AM Depth 2-6
Setting the AM Rate 2-7
Turning On Amplitude Modulation 2-7
Setting Up Internally-Generated Frequency Modulation 2-8
Setting the Carrier Frequency 2-8
Setting the Power Level 2-8
Setting the FM Deviation 2-8
Setting the FM Rate 2-9
Turning On Frequency Modulation 2-9
To Next Page
Loading...
