5-65
Hardkey and Softkey Reference
Incr Set
Incr Set
Press this front panel hardkey to change the incremental value of the up and down
arrow keys for the current active function. For example, press
Frequency to make
it the active function. The current frequency is shown in the active entry area. The
incremental value for frequency is set to 1 MHz at the factory. Press
Incr Set and
the incremental value of the up and down arrow keys for frequency becomes the
active function. You can change the value by using three different methods:
• Use the up and down arrow keys.
The arrow keys will change the incremental value in steps equal to the current
incremental value (in this example, these are 1 MHz steps.)
• Use the front panel knob.
• Use the numeric keypad and complete your entry with a terminator softkey.
Press Incr Set again and the active function toggles, making frequency the active
function again.
Incremental values are persistent states; they are not affected by an instrument
preset or by a power cycle.
To Next Page
Loading...
Need help?
General
