HP ESG Series - Swept-Sine; Triangle

5-83
Hardkey and Softkey Reference
LF Out
Swept-Sine
Pressing this softkey reveals a menu of choices for setting the swept-sine low
frequency output. In this menu you can set the LF start and stop frequency and the
sweep time. You can also set the trigger for the swept-sine output, and the polarity
of the TRIGGER IN and TRIGGER OUT signals.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, Swept-Sine
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:SHAPe SWEPtsine
[:SOURce]:LFOutput:FUNCtion:SHAPe?
Triangle
This softkey lets you specify triangle as the waveform for the LF output signal.
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, Triangle
Status after Normal Preset: LF Out Waveform is set to Sine
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:SHAPe TRIangle
[:SOURce]:LFOutput:FUNCtion:SHAPe?