EasyManuals Logo

HP ESG Series User Manual

HP ESG Series
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #257 background imageLoading...
Page #257 background image
5-148
Hardkey and Softkey Reference
Sweep/List
Ampl
Press this softkey to set the signal generator to sweep amplitude data only. The
frequency is set at a constant value determined by the
Frequency front panel key.
You can define a sweep containing both amplitude and frequency information and
still choose to sweep amplitude only.
Softkey Location: Press
Sweep/List, Sweep, Ampl
Status after Normal Preset: Sweep is set to Off
SCPI Commands:
[:SOURce]:POWer:MODE LIST
[:SOURce]:POWer:MODE?
Ampl Start
Press this softkey to set the amplitude of the first point in the sweep. You can set
the value anywhere in the range of the signal generators specified output power.
Press
Ampl Start and amplitude becomes the active function for the first point in
the sweep. To enter the value, rotate the front panel knob until the desired value is
displayed, use the up and down arrow keys, or enter the value using the numeric
keypad and press the
dBm, dBuV, dBuVemf, mV, uV, mVemf, or uVemf terminator
softkey.
Softkey Location: Press
Sweep/List, Configure Step Sweep, Ampl Start
Status after Normal Preset: 135 dBm
SCPI Commands:
[:SOURce]:POWer:STARt <val><unit>
[:SOURce]:POWer:STARt?

Table of Contents

Other manuals for HP ESG Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ESG Series and is the answer not in the manual?

HP ESG Series Specifications

General IconGeneral
BrandHP
ModelESG Series
CategoryPortable Generator
LanguageEnglish

Related product manuals