5-144
Hardkey and Softkey Reference
Save
Editing Mode Insert Replace
Press this softkey to toggle the editing mode from inserting text to replacing text.
Insertion mode causes text to be entered in the position directly to the right of the
cursor. Replacement mode causes the text to be entered in the position held by the
cursor (replacing any existing text in that position).
Softkey Location: Press
Save, Add Comment To Seq[n] Reg[nn], Editing Keys,
Editing Mode Insert Replace
Save Seq[n] Reg[nn]
Press this softkey to save the current instrument state in the specified register and
sequence. The instrument state includes all of your setup selections except list and
step sweep data and functions which are identified in this manual as persistent
states.
Do not press this softkey until you have specified the correct sequence and
register using the
Select Seq and Select Reg softkeys. For example, if you want to
save to register 5 in sequence 4, press
Select Seq. The currently selected sequence
is displayed in the active entry area. Change the number to 4 using the up and
down arrow keys, the front panel knob, or enter a 4 using the numeric keypad and
press the
Enter terminator softkey. Sequence 4 is now displayed in all softkeys
which specify a sequence in this menu. Now select register 5, press
Select Reg.
The currently selected register is displayed in the active entry area. Change the
number to 5 in the same way that you changed the sequence number. Register 5 is
now displayed in all softkeys which specify a register in this menu. Now press
Save Seq [4] Reg[05] and the current instrument state will be stored in register 5 of
sequence 4.
There are 100 registers available (0 through 99) in each of 10 (0 through 9)
sequences. You can use these registers in any combination so long as the total
number of registers used does not exceed 100.
Softkey Location: Press
Save, Save Seq[n] Reg[nn]
IEEE 488.2 Common Commands:
*SAV <reg>[, <seq>]
To Next Page
Loading...
