HP ESG Series - Φ M Stop Rate; M Sweep Time

5-103
Hardkey and Softkey Reference
Phase Modulation
ΦM Stop Rate
Use this softkey to change the ending internal modulation frequency for
swept-sine phase modulation. To change the value, press the softkey once. The
current value for the
ΦM stop rate is displayed in the active entry area. To enter a
new value, rotate the front panel knob until the desired value is displayed, use the
up and down arrow keys, or enter the value using the numeric keypad and press
the
Hz or kHz terminator softkey. The range of values allowed is 0.1 Hz to 50 kHz.
The minimum increment allowed is 0.1 Hz.
This softkey is coupled to the
ΦM Tone 2 Rate softkey in the ΦM Dual-Sine Menu.
Any value set for
ΦMStopRate is reflected in the ΦMTone2Rate softkey.
Conversely, if you change the value for the
ΦM Tone 2 Rate softkey, the value for
ΦMStopRate is changed to match.
Softkey Location: Press
FM/ΦM hardkey, toggle FM/ΦM softkey to ΦM, press
More (1 of 2), ΦM Waveform, Swept-Sine, ΦMStopRate
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency:ALTernate <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency:ALTernate?
Φ
M Sweep Time
Press this softkey to set the sweep time for swept-sine phase modulation. The
signal generator will vary the
ΦM rate from the specified start rate to the stop rate
in the time set with this softkey. Enter the desired sweep time using the up and
down arrow keys, the front panel knob, or enter a value using the numeric keypad
and press the
sec or msec terminator softkey. The range of values allowed is 1 ms
through 65.535 s. The minimum increment allowed is 1 ms.
Softkey Location: Press
FM/ΦM hardkey, toggle FM/ΦM softkey to ΦM, press
More (1 of 2), ΦM Waveform, Swept-Sine, ΦMSweepTime
Status after Normal Preset: 100.0 msec
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TIME <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TIME?