HP ESG Series - Square; Swept-Sine; Triangle

5-18
Hardkey and Softkey Reference
AM
Square
This softkey lets you specify square as the amplitude modulation waveform for
the
AM Path 1 and AM Path 2 configurations. Notice that the selected waveform
applies only to whichever AM path configuration you have currently selected.
Softkey Location: Press
AM, AM Waveform, Square
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe SQUare
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe?
Swept-Sine
Pressing this softkey reveals a menu of choices for setting the swept-sine
amplitude modulation parameters. In this menu you can set the start and stop AM
rate and the sweep time. You can set the signal generator to a single,
externally-triggered sweep on either a negative or positive TTL level or you can
choose continuous sweep, triggered immediately. In this menu you can also select
either a positive or negative polarity for the TRIGGER OUT signal.
Softkey Location: Press
AM, AM Waveform, Swept-Sine
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe SWEPtsine
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe?
Triangle
This softkey lets you specify triangle as the amplitude modulation waveform for
the
AM Path 1 and AM Path 2 configurations. Notice that the selected waveform
applies only to whichever AM path configuration you have currently selected.
Softkey Location: Press
AM, AM Waveform, Triangle
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe TRIangle
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe?