5-141
Hardkey and Softkey Reference
Save
Save
Pressing the front panel Save key reveals a menu of softkeys. These softkeys are
described in this section in alphabetical order.
When you press the
Save key, the text area of the display shows the registers in
use and any comments associated with the registers for the last sequence accessed.
The display is updated whenever you make any changes to the registers or to the
comments.
Add Comment To Seq[n] Reg[nn]
Press this softkey to add a comment that is associated with a register in use. The
register number is listed in the text area of the display and the comment is shown
immediately following the register. You can use the comment line, for example, to
identify the instrument state saved in a register.
The comment line can consist of up to 55 alpha-numeric characters and special
characters. To add or change a comment, the following editing capabilities are
provided:
• The Editing Mode Insert Replace softkey in the Editing Keys menu toggles the
editing mode from inserting text to replacing text. Insertion mode causes text to
be entered in the position directly to the right of the cursor. Replacement mode
causes the text to be entered in the position held by the cursor (replacing any
existing text in that position).
•The Clear Text softkey in the Editing Keys menu deletes all of the existing text in the
active entry area.
•
Use the left and right arrow keys to position the cursor. Use the front panel
knob, up and down arrow keys, or the direct editing softkeys, to enter an
alphabetic character, numeral, or special character.
When you have entered the comment text, press the
Enter terminator softkey. If
you have changed your mind, press the
Return hardkey. Once you press Enter, the
new comment is saved to your selected register and displayed immediately.
To Next Page
Loading...
