HP ESG Series - LF out Stop Freq

5-75
Hardkey and Softkey Reference
LF Out
LF Out Stop Freq
Use this softkey to change the ending frequency for swept-sine low frequency
output. To change the value, press the softkey once. The current value for the LF
Out stop frequency is displayed in the active entry area. To enter a new value,
rotate the front panel knob until the desired value is displayed, use the up and
down arrow keys, or enter the value using the numeric keypad and press the
Hz or
kHz terminator softkey. The range of values allowed is 0.1 Hz to 50 kHz. The
minimum increment allowed is 0.1 Hz.
This softkey is coupled to the
LF Out Tone 2 Freq softkey in the LF Out Dual-Sine
Menu. Any value set for
LF Out Stop Freq is reflected in the LF Out Tone 2 Freq
softkey. Conversely, if you change the value for the
LFOutTone2Freq softkey,
the value for
LF Out Stop Freq is changed to match.
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, Swept-Sine, LF Out Stop Freq
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:FREQuency:ALTernate <val><unit>
[:SOURce]:LFOutput:FUNCtion:FREQuency:ALTernate?