HP ESG Series - Sweep; Sweep Direction down up

5-162
Hardkey and Softkey Reference
Sweep/List
9. Now press the Enter terminator softkey and the list sweep data is saved with the file
name, FREQ 1453 to 1465 MHZ. The characters @LIST are automatically
appended to the file name as file type identification.
Softkey Location: Press Sweep/List, Configure List Sweep, More (1 of 2),
Load/Store, Store To File
SCPI Commands:
:MEMory:STORe:LIST <filename>
:MMEMory:STORe:LIST <filename>
Sweep
Pressing this softkey reveals a menu of choices for determining the sweep
parameters. In this menu you can choose to sweep frequency only, amplitude only,
or both frequency and amplitude. You can also choose to turn off all sweep
functions.
Softkey Location: Press
Sweep/List, Sweep
Status after Normal Preset: Off
SCPI Commands:
[:SOURce]:FREQuency:MODE CW|FIXed|LIST
[:SOURce]:FREQuency:MODE?
[:SOURce]:POWer:MODE FIXed|LIST
[:SOURce]:POWer:MODE?
Sweep Direction Down Up
This softkey changes the direction of the sweep. Choose Up to sweep from the
first point in the list to the last point, or from the step sweep start frequency and
amplitude to the stop frequency and amplitude. Choose
Down to reverse the
direction of the sweep.
Softkey Location: Press
Sweep/List, More (1 of 2), Sweep Direction Down Up
Status after Normal Preset: Up
SCPI Commands:
[:SOURce]:LIST:DIRection UP|DOWN
[:SOURce]:LIST:DIRection?