5-68
Hardkey and Softkey Reference
LF Out
DC
This softkey lets you specify DC as the waveform for the LF output signal.
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, More 1 of 2, DC
Status after Normal Preset: LF Out Waveform is set to DC
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:SHAPe DC
[:SOURce]:LFOutput:FUNCtion:SHAPe?
Dual-Sine
Pressing this softkey reveals a menu of choices for setting the dual-sine low
frequency output parameters. In this menu you can set the frequencies for two
separate tones. In addition you can set a ratio of the tone 2 LF amplitude to the
tone 1 LF amplitude.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, Dual-Sine
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:SHAPe DUALsine
[:SOURce]:LFOutput:FUNCtion:SHAPe?
To Next Page
Loading...
