HP ESG Series - Configure List Sweep; Configure Step Sweep

5-150
Hardkey and Softkey Reference
Sweep/List
Configure List Sweep
Pressing this softkey reveals a menu of softkeys for defining a list sweep. In this
menu you can insert and delete points in a sweep. Each point can contain
frequency, amplitude, and dwell time information. The list point information is
stored in three binary files: FREQ_FILE, POW_FILE, and DWEL_FILE. These
files will survive a preset but not a power cycle. If they are deleted, the signal
generator will recreate these files as needed. In this menu you can also edit
existing points in the sweep.
Softkey Location: Press
Sweep/List, Configure List Sweep
SCPI Commands:
[:SOURce]:LIST:DWELl <val>{, <val>}
[:SOURce]:LIST:DWELl?
[:SOURce]:LIST:DWELl:POINts?
[:SOURce]:LIST:FREQuency <val>{, <val>}
[:SOURce]:LIST:FREQuency?
[:SOURce]:LIST:FREQuency:POINts?
[:SOURce]:LIST:POWer <val>{, <val>}
[:SOURce]:LIST:POWer?
[:SOURce]:LIST:POWer:POINts?
Configure Step Sweep
Pressing this softkey reveals a menu of softkeys for defining a step sweep. In this
menu you can set the start and stop frequencies for a sweep, set the start and stop
power levels, and you can set the number of points in the sweep with the dwell
time at each point.
Softkey Location: Press
Sweep/List, Configure Step Sweep