HP MSR SERIES User Manual

382
Figure 385 Setting up a GRE tunnel
4. Configure a static route from Router B through interface Tunnel 0 to Group 1:
a. Select Advanced > Route Setup from the navigation tree.
b. Click the Create tab and then perform the configurations shown in Figure 386.
c. Enter 10.1.
1.0 as the destination IP address.
d. Enter the mask length 24.
e. Select the box before Interface, and then select egress interface Tunnel0.
f. Click Apply.
Figure 386 Adding a static route from Router B through interface Tunnel 0 to Group 1
Verifying the configuration
On Router B, ping the IP address of Ethernet 0/0 of Router A:
1. Select Other > Diagnostic Tools from the navigation tree of Router B.
2. Click the Ping tab.
3. Enter the destination IP address 10.1.1.1.
4. Click Start.
5. View the result of the ping operation in the Summary area.

HP MSR SERIES Specifications

General

Product Series	MSR Series
Manufacturer	HP
Category	Network Router
Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Varies by model
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Weight	Varies by model
Wireless Support	Varies by model
Management	Web-based, CLI
Power Supply	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing