HP MSR SERIES - Page 692

675
10. Enter 1.1.1.2 for Destination Address.
11. Click Apply.
Configuring the SIP trunk device
# Enable the SIP trunk function.
1. Select Voice Management > SIP Trunk Management > Service Configuration from the navigation
tree.
Figure 703 Configuring services
2. Select Enable for SIP Trunk Function.
3. Click Apply.
# Create SIP server group 1. Add a SIP server into the server group: the ID and the IPv4 address of the
server are 1 and 10.1.1.2 respectively.
4. Select Voice Management > Call Connection > SIP Server Group Management from the navigation
tree and click Add.
Figure 704 Configuring server group