HP V1910 Switch Series - AAA configuration; Introduction to AAA

328
 Select the check box before Enable 802.1X.
 Select the authentication method as CHAP.
 Click Apply to finish the operation.
# Enable and configure 802.1X on port GigabitEthernet 1/0/1.
 In the Ports With 802.1X Enabled area, click Add.
Figure 292 802.1X configuration of GigabitEthernet 1/0/1
 Select port GigabitEthernet1/0/1 from the port drop-down list.
 Select the checkbox before Enable Re-Authentication.
 Click Apply to finish the operation.
3. Configure the RADIUS scheme system.
# Configure the RADIUS authentication servers.
 From the navigation tree, select Authentication > RADIUS. The RADIUS server configuration page
appears.