Inertial Labs INS-P User Manual

INS
GUI User’s Manual
Inertial Labs, Inc
TM
Address: 39959 Catoctin Ridge Street, Paeonian Springs, VA 20129 U.S.A.
Tel: +1 (703) 880-4222, Fax: +1 (703) 935-8377 Website: www.inertiallabs.com
123
Fig. 10.19
All time of data accumulation and performing of necessary calibrations for
calibration the INS unit continues its operation, calculates and outputs the
navigation data.
Note: after calculation of parameters of on-the-fly VG3D calibration they are
being used for compensation of the carrier’s hard and soft iron, but they are
not saved to the INS flash memory until INS unit is stopped by click the
“Stop” button (see Fig. 10.18). If INS unit is stopped by power off, then
parameters of on-the-fly VG3D calibration cannot be stored to the INS flash
memory. In the last case at the next run INS unit should be calibrated again.
Note: VG3D calibration is at the testing stage. Please contact Inertial Labs about the
possibility of using the VG3D calibration.

Inertial Labs INS-P Specifications

General

Brand	Inertial Labs
Model	INS-P
Category	Car Navigation system
Language	English