Inficon HAPSITE ER - Tune Reports

4 - 54
HAPSITE ER Operating Manual
Figure 4-91 Run AutoTune
Touching the TUNE STATUS icon will also provide the file name of the last tune
report, the time the instrument tuned, and the date the instrument tuned. It will also
show a countdown of the time to the next tune check.
The pressure of the MS at the last AutoTune will be displayed. If a method is being
run or manual tune is open, the current MS pressure will also be displayed. If a
method is not running and the last tune pressure was within range, an Acceptable
message will be displayed.
4.7.1.5.1 TUNE REPORTS
After the TUNE STATUS icon has been touched, see Figure 4-92, a new button,
TUNE REPORTS, will be shown at the bottom of the screen. This button accesses
data from past Tune Reports. (See Figure 4-93.) For more information on Tune
Reports, see Chapter 9, Tune.
Figure 4-92 Tune Status Icon