Inficon HAPSITE ER - Attaching the Probe

3 - 6
HAPSITE ER Operating Manual
3.2.1 Attaching the Probe
The probe attaches on the top of HAPSITE ER. The probe has two connections: a
LEMO
®
communication line and a Valco connector.
1 Remove the silver LEMO port cap from the HAPSITE ER by pulling it outwards.
Store the port cap for future use. (See Figure 3-3.)
Figure 3-3 Silver LEMO Port
2 Unscrew the Valco connector port cap. Store the port cap for future use.
(See Figure 3-4.)
Figure 3-4 Valco Connector
3 Align the red dots on the LEMO communication line with the red dots on the
port. Insert the line into the port. (See Figure 3-5.)
Figure 3-5 Aligning Red Dots