10 - 13
HAPSITE ER Operating Manual
Figure 10-14 SituProbe Temperatures
SPME
SPME Fiber . . . . . . . . . . . . . . . . . . . Type in the color of the desired fiber into the
box. See Figure 10-15.
Figure 10-15 SPME Fiber
10.6 Inlet Page
NOTE: This page is only available when creating an Analyze (GC/MS) method.
The Inlet page displays the default settings for the Inlet States, GC Temperature
Profiles and Valve States. Adjusting settings on the Inlet page may affect other
method parameters and/or the retention time. The Start time of each Inlet State
event is displayed in combination with the temperature profile at the bottom of the
Inlet page. See Figure 10-16.