Inficon HAPSITE ER - Detecting Hazardous Chemicals

4 - 30
HAPSITE ER Operating Manual
4.4.4 Quick Reference SOP — Concentrator Methods
1 Verify that the concentrator is installed.
2 Refer to section 4.1.4, Quick Reference SOP - Heat-up and Tune, on page 4-12
for startup instructions.
3 Verify that the desired method is displayed on the Analyze line.
4 Touch RUN ANALYZE or push ANALYZE RUN when the SYSTEM IS READY
screen is displayed.
5 When the screen prompts, Collect Sample Now, hold the probe over the
sample until the screen prompts, Sampling Is Done.
6 When the run is complete, a Method Finished prompt will be displayed.
7 Refer to section 4.5.1, View Results/View Reports, on page 4-31 for
information on data review.
4.5 Detecting Hazardous Chemicals
If the HAPSITE ER Analyze message turns red, the chemical’s concentration is
either approaching the IDLH limit or the chemical is a Chemical Warfare Agent. In
CMPD ID mode, the compound will be highlighted in red and in GRAPH mode, the
name of the compound will be written in red. Red arrows on the side of the screen
will be displayed in GRAPH mode if there is more than one red compound. (See
Figure 4-50.)
Figure 4-50 IDLH Warnings