11 - 21
HAPSITE ER Operating Manual
11.3.4 Analytes
Analytes in Library. . . . . . . . . . . . . Displays the analytes in the library.
Analytes in File. . . . . . . . . . . . . . . . Displays the analytes in the currently
displayed or selected file.
Search Results in File . . . . . . . . . . If a search has been performed with Search
for Analytes selected, a review of the
analytes detected in the file is enabled.
Individual analytes can then be added to the
template by right clicking on the compound
name and selecting Add To Template. To
add all compounds detected in the file, select
Add All. (See Figure 11-54.)
Figure 11-54 Search Results in File
11.3.5 Reports
View Calibration Reports refer to section 10.10.7, View Reports, on page 10-57:
Calibration Response Table . . Report that displays the response factor and
curve statistics based on the selected curve
type.
Calibration Report . . . . . . . . . . Report that displays the area fit and purity for
the calibration standards.
NIST Search . . . . . . . . . . . . . . . . . . The initial search when building a
template/library is performed using the
AMDIS library. If peaks are detected and
loaded into the template without an
identification, the NIST Search can be used
to identify these compounds.
To Next Page
Loading...
