Inficon HAPSITE ER - Properties Menu

8 - 56
HAPSITE ER Operating Manual
Clear the Peaks. . . . . . . . . . . . . Clears the identification of peaks from the
TIC graph after using Search for Peaks.
Label the Peaks . . . . . . . . . . . . Labels identified peaks with retention time
and area.
Change Search Parameters. . . Modifies current peak search parameters.
Refer to section 10.10.2, Setting Up a
Quantitative Search, on page 10-43.
Previous Search Results . . . . . View results from a previous search. (Drop-
down menu of previously opened data files.)
TIC Graph . . . . . . . . . . . . . . . . . . . . When checked, displays TIC window.
RIC Graph . . . . . . . . . . . . . . . . . . . . When checked, displays the RIC window.
Spectrum Scan ### . . . . . . . . . . . . When checked, displays Spectrum window
for the current scan.
Control Panel . . . . . . . . . . . . . . . . . When checked, displays the Control Panel.
Properties . . . . . . . . . . . . . . . . . . . . Allows access to the Properties of the
display. See section 8.11.1.1, Properties
Menu, on page 8-56.
8.11.1.1 Properties Menu
The Properties option displays the following options: (See Figure 8-116.)
Current Width . . . . . . . . . . . . . . . . . The width of the graph can be set to the
desired time point.
Show Spectrum . . . . . . . . . . . . . . . The Spectrum will be automatically
displayed upon opening a data file when this
box is checked.
Show Control Panel . . . . . . . . . . . . The Control Panel will be automatically
displayed upon opening a data file when this
box is checked.
Use Scan Range . . . . . . . . . . . . . . . The masses for the scan range of the method
will be displayed.
Low Mass Limit. . . . . . . . . . . . . . . . HAPSITE will display masses in the
spectrum above this limit.
High Mass Limit . . . . . . . . . . . . . . . HAPSITE will display masses in the
spectrum below this limit.