Inficon HAPSITE ER - Setting the Full Scan Range

9 - 24
HAPSITE ER Operating Manual
. . . . . . . . . . . . . . . . . Increases the peak resolution.
. . . . . . . . . . . . . . . . . Decreases the peak resolution.
. . . . . . . . . . . . . . . . . Shifts the mass peak right.
. . . . . . . . . . . . . . . . . Decreases the Ion Energy.
. . . . . . . . . . . . . . . . . Increases the Ion Energy.
. . . . . . . . . . . . . . . . . Zooms to a single peak scan display window.
9.4.12 Setting the Full Scan Range
Placing the mouse cursor on the x axis of the full scan window and right-clicking
will display the Set Full Scan Range window, see Figure 9-37. This allows a
custom scan range to be entered. The scan ranges of 45 to 300 amu or 1 - 45 amu
can also be selected.
Figure 9-37 Setting the Full Scan Range
NOTE: The EM voltage will automatically be decreased by 500 volts (default)
whenever a range below mass 45 is scanned.