11 - 29
HAPSITE ER Operating Manual
Search Settings . . . . . . . . . . . . . . . Displays the search parameter settings. See
section 8.7.0.2, Peak Search Parameters, on
page 8-33.
Unknown Reports
By File . . . . . . . . . . . . . . . . . . . . Displays report by file.
By Analyte . . . . . . . . . . . . . . . . . Displays report by analyte.
11.6.2 Data Files
Browse . . . . . . . . . . . . . . . . . . . . . . Used to select the data file for analysis.
Display . . . . . . . . . . . . . . . . . . . . . . Will display a chromatogram with a T over
the compounds found in the calibration
report. See section 11.7.
File Entry. . . . . . . . . . . . . . . . . . . . . Lists the reference number for the file.
Data File Name . . . . . . . . . . . . . . . . Displays the data file name and pathway.
11.6.3 Peak Search
Search . . . . . . . . . . . . . . . . . . . . . . . Performs a peak detection and integration on
the selected files. It produces the quantitative
report.
Recalculate . . . . . . . . . . . . . . . . . . . Recalculates the peak areas and response
factors without performing a peak search.
This is most useful after manually editing the
baseline points of a peak.
Start . . . . . . . . . . . . . . . . . . . . . . . . . Initiates the search for peaks or recalculates
the peak search.
11.6.4 Analytes
Analytes in Library. . . . . . . . . . . . . Displays the analytes in the library.
Analytes in File. . . . . . . . . . . . . . . . Displays the analytes in the currently
displayed or selected file.
11.6.5 Reports
Calibration Response Table . . . . . Report that displays the response factor and
curve statistics based on the selected curve
type.
Calibration Report . . . . . . . . . . . . . Report that displays the area fit and purity for
the calibration standards.
To Next Page
Loading...
