5 - 1
HAPSITE ER Operating Manual
Chapter 5
Communications and Touch Screen Options
5.1 Communications
HAPSITE ER has two communication options: the cross-over cable and the
wireless connection. The wireless settings will be configured with the laptop at the
factory. Before connecting wirelessly, the wireless radio on HAPSITE ER and the
wireless button on the laptop will have to be enabled. Follow the instructions below
to turn on the radio. Refer to section 3.2.4, Connecting the Laptop, on page 3-14
for instructions on attaching the laptop.
5.1.1 Wireless Range
HAPSITE is equipped with an 802.11b/g wireless adapter. The typical range for
a signal is 300 feet (100 meters) with no obstructions. The following may degrade
the signal:
Metal buildings
Concrete structures
Electric devices in the area
5.1.2 Turning On the Radio
This procedure gives instructions for turning on the radio, which is necessary for
wireless communication.
When the HAPSITE ER radio is on, even if wireless
communication is not being used, a radio signal is being
transmitted. The only way to eliminate the radio signal is
to turn the radio off.
1 Open the front panel of HAPSITE ER.