10 - 22
HAPSITE ER Operating Manual
10.7.1 Param Page
The Param tab (see Figure 10-27) displays the tune filename, which sets the MS
tune parameters for the method. The default filename is
default.tun. If a
different tune file is desired, the Browse button can be used to locate and specify
the desired tune for the method.
This page also has a Show Details checkbox (Figure 10-28), which will produce a
grid of tune parameters contained in the file. These parameters cannot be edited.
If editing is desired, refer to Chapter 9, Tune.
Figure 10-27 Method Editor Tune Parameter Page
To Next Page
Loading...
