Inficon HAPSITE ER - Quick Reference SOP - Tri-Bed Concentrator Method; Selecting a New Method

6 - 11
HAPSITE ER Operating Manual
6.3.3 Quick Reference SOP — Tri-Bed Concentrator Method
1 Verify that the concentrator is installed.
2 If the system is shutdown or in Extended Standby, either power on HAPSITE
or take the system out of Extended Standby. HAPSITE will begin preparing a
concentrator method.
3 When HAPSITE has finished preparing, a prompt to press Run will be
displayed on the laptop screen.
4 When the screen prompts, Collect Sample Now For, hold the probe over the
sample until the screen prompts, Sampling is Done.
5 When the run is complete, a Method Finished prompt will be displayed.
6 See section 4.5.1, View Results/View Reports, on page 4-31 or Chapter 8, Data
Review for information on data review.
CAUTION
Do not place the sample probe in liquids while sampling.
6.4 Selecting a New Method
1 Click the Abort button. (See Figure 6-20.)
Figure 6-20 Aborting method
2 Double-click on the Run Method icon. A dialog is displayed for selecting the
desired method. In the example below, ER_Air_Tri-Bed_PPB_Standard will
be selected.