7 - 39
HAPSITE ER Operating Manual
7.8.1 Update HAPSITE Software
Periodically, a software update for HAPSITE ER may be available. Clicking the
Update HAPSITE Software option, allows the user to select the software update
file. Once selected, the update will be loaded onto the analytical module and the
analytical module will restart. For complete installation instructions, refer to the
Software Installation Instructions that are located on the update CD, as instructions
for each update may vary.
NOTE: All update files will have the .upd extension.
Latest versions of the HAPSITE software, along with instructions for loading these
onto the unit, can be downloaded from the INFICON website, Software Downloads
page: http://www.inficon.com/tabid/244/en-US/default.aspx.
7.8.2 Bring Online
If HAPSITE ER is not communicating when connecting through the Ethernet cable,
clicking on the Bring Online option will attempt to re-establish communication. If
the connection has been manually disabled, clicking Bring Online will re-enable
the connection. When the connection is active, the HAPSITE Sensor icon will not
be overlaid with an “X”.
7.8.2.1 Communication Messages
If the laptop is not communicating with HAPSITE ER, there are three types of “X’s”
that may be displayed.
The red “X” signifies that communication was suddenly lost. For example, an
Ethernet cable was disconnected.
The blue “X” signifies that communication has yet to be established.
The gray “X” signifies that communication has been disabled through ER IQ by
using the Disconnect option.
7.8.3 Disconnect
The Disconnect option will manually disconnect the laptop from HAPSITE ER and
will remain disconnected until Bring Online is selected.
To Next Page
Loading...
