Inficon SQC-310

6 - 15
PN 074-550-P1D
SQC-310 Operating Manual
Figure 6-1 Button number designations
To clear all memory including the material index, press and hold the 1 and 6 buttons
along with the control knob (7) during startup. On the bootup screen, the following
should be displayed:
Loading Materials . . . . . . . . . . . . Failed!
Loading Films . . . . . . . . . . . . . . . Failed!
Loading System . . . . . . . . . . . . . Failed!
Loading Processes. . . . . . . . . . . Failed!
Once SQC-310 boots up, turn the power off and back on again. SQC-310 loads
normally and displays:
Loading Materials . . . . . . . . . . . . Done
Loading Films . . . . . . . . . . . . . . . Done
Loading System . . . . . . . . . . . . . Done
Loading Processes. . . . . . . . . . . Done
If any Failed! messages still appear during loading, turn the power off and back on
again. Only Done messages should appear after memory clearing is complete.
To clear all memory except the material index and set SQC-310 to factory default,
press and hold the 2 and 5 buttons along with the control knob (7) during startup.
All loading messages will now display Failed!, except Materials. Repeat the
rebooting procedure described above until all loading messages display Done.