Chapter 2: Installation
Before Installing This Device
34/ 526 2.0 Eclipse User Guide
Before Installing This Device
Warning
Please read and observe ALL of the following notes before
installing this product:
• Check all of the hardware devices for transport damage.
• Any devices showing signs of mechanical damage or
damage from the spillage of liquids MUST NOT be
connected to the mains supply or disconnected from the
mains immediately by pulling out the power lead.
• All devices MUST be connected to the mains using the
three-cord power leads supplied with the system. Only
supply electrical interfaces with the voltages and signals
described in these instructions.
• All devices MUST be grounded. Grounding connectors
are provided on all devices. If the power cord has a
three-pin plug, it will provide sufficient grounding so long
as the AC socket is grounded correctly.
• Do not store or use the system at extreme temperatures,
or in an environment with exposure to vibration, dust or
humidity.
• Do not block the ventilation holes when installing the
device. Blocked ventilation holes are a fire hazard.
• Do not place the device (console or audio rack) too
close to strong electromagnetic radiation sources (video
monitors, high-voltage cables, etc.), as this might cause
a degradation of audio quality via induced currents in the
connections and frame.
• Never connect a device (e.g. camera) that has its own
phantom power activated as this will destroy the input or
output. Switch the phantom power off, or if this is not
possible, go through an external device first (isolation
transformer, intermediate pre-amp, etc.).
• The control surface panels and individual card
components contain no user-serviceable parts.
Therefore do not open the devices other than to perform
the procedures described in this manual.
• Any swapping of modules MUST be performed with the
device switched off and disconnected from the mains
supply.
To Next Page
Loading...
