Chapter 4: Getting Started (The Standard Template)
Signal In to Out
94/ 526 2.0 Eclipse User Guide
Signal In to Out
Normally on Eclipse, there are three operations required to get
signal through the console:
• PATCH IN – patch your audio sources to input channels
• ROUTE – assign your input channels to your Master and
other outputs (Auxes, Groups, etc.)
• PATCH OUT – patch your Master and other outputs to
their physical destinations.
By loading the Templ1 File you already have a console with
inputs and outputs patched, and with routing assignments
made. This means that you can literally open some input
faders, open the stereo Master and start mixing!
If you want to do this right now, skip to Page 100. If you’d like to
view or modify any of the default patching or routing, read on.
To Next Page
Loading...
