Chapter 7: Reset and Automation
Automation Enable Buttons
Eclipse User Guide 2.0 381/ 526
Automation Enable Buttons
The MIDI buttons on the right of the Main Mix display allow you
to enable or disable automation functions defined within the
Play List. In each case, the buttons are green when enabled:
• in – when enabled, Page changes will be actioned from
MIDI program changes received at the MIDI IN
connector at the rear of the console.
• out – when enabled, MIDI program changes are output
to the MIDI OUT connector at the rear of the console.
• TC - when enabled, Page changes will be actioned from
MIDI timecode (MTC) received at the MIDI IN connector.
• start - when enabled, fader starts programmed from the
FADER START display will send MIDI Note On and
Note off messages to the MIDI OUT connector.
• crossfade – enable this option to activate crossfade
automation.
Keyboard Shortcuts
The in, out and crossfade automation enable buttons can also
be actioned from the console keyboard:
• in – press [ALT] + [X].
• out – press [ALT] + [Y].
• crossfade – press [ALT] + [D].
Or from switches on the User Defined panel, see Page 322.
To Next Page
Loading...
