Chapter 4: Getting Started (The Standard Template)
Loading a File
Eclipse User Guide 2.0 89/ 526
Loading a File
Console settings are stored and recalled from “Files” where
each File may contain one or more “Pages”. Think of each File
as your show, and each Page as a snapshot of settings to be
loaded during that show.
To reduce your setup time each console is shipped with a pre-
installed File named Templ1 which contains a single Page
snapshot named INNOVA.
The template defines a typical user configuration where input
channels, VCAs, Auxes, a stereo Master and Matrix busses are
all pre-assigned to the console surface. Default input, output
and internal effects patching are also implemented so all you
need to do is connect your microphones, PA or monitors to the
correct I/O and you will have audio.
For specific details on the connections defined by Templ1,
please see Appendix A.
Warning
When you load an unknown file you may load settings which
cause audio to pass through the console. Therefore, make sure
any amplifiers, headphones, etc. are turned off or at a safe
operating level before you load.
To load the file:
1. Using the trackball select “FILE -> Load” from the main
menus.
The FILE LOAD window appears on the Nova screen:
2. Select the File you wish to load – Templ1.
3. Confirm by pressing OK.
To Next Page
Loading...
