Chapter 8: Utilities & Preferences
Over Ram
Eclipse User Guide 2.0 399/ 526
Over Ram
This function writes parameters from a selected channel or
channels into other Pages in RAM. Thereby allowing you to
modify settings for the Pages which will play out during a show.
For example, if at the beginning of a show you realise that an
instrument is too low in the mix, you can raise its level and then
write this new fader level into all Pages in RAM. This function
overwrites settings in RAM, therefore it is called Over Ram.
Note that parameters are updated according to their absolute
values; you cannot trim an existing value.
Note that the Over Ram display acts only on channels of the
console. If you wish to Over Ram parameters for a source or
destination which is not assigned to the surface, such as a
talkback microphone, then use OVERRAM from the PATCH
DIRECT grid, see Page 258.
1. Press Over Ram on the UTILITIES panel to open the
OVERRAM display:
If you are working offline, you can select the OVERRAM display
from the UTIL main menu:
Over Ram
(UTILITIES)
“UTIL ->
Over Ram”
n/a
To Next Page
Loading...
