ISHIDA DACS-W User Manual

8 ADDITIONAL FUNCTIONS DACS-W Operation Manual
8-24
8.4.3.5 Tare Subtraction
This parameter is set to ON when Tare Subtraction is to be used.
Setting is performed as described below.
8.4.3.6 Dynamic Calibration
This parameter is set to ON when Dynamic Calibration is to be used.
Setting is performed as described below.
1. Display the System Configuration menu.
2. Press or to align the cursor with
"Tare Subtraction".
3. Press .
The Tare Subtraction menu appears.
4. To set tare subtraction OFF, Press [0].
To set tare subtraction ON, Press [1].
The setting for this parameter will appear on
the System Configuration menu.
Figure 8-60 System Configuration Menu
Figure 8-61 Tare Subtraction Menu
1. Display the System Configuration menu.
2. Press or to align the cursor with
"Dynamic Calibration".
3. Press .
The Dynamic Calibration menu appears.
4. To set Dynamic Calibration OFF, Press [0].
To set Dynamic Calibration ON, Press [1].
The setting for this parameter will appear on
the System Configuration menu.
Figure 8-62 System Configuration Menu
Figure 8-63 Dynamic Calibration Menu
ENTER

▼

▲

SELECT
ITEM
[System Configuration]
* Printer ON
* Tare Subtraction ON
*
Reject Device
Integrated
[Tare Subtraction]
0...OFF
1... ON
1
ENTER

▼

▲

SELECT
ITEM
[System Configuration]
* Reject Device Arm3 (W)
* Tare Subtraction ON
* Dynamic Calibration ON
[Dynamic Calibration]
0...OFF
1... ON
1

ISHIDA DACS-W Specifications

General

Brand	ISHIDA
Model	DACS-W
Category	Measuring Instruments
Language	English