ISHIDA DACS-W - Outline of Production Sequence

DACS-W Operation Manual 6 PRODUCTION
6-3
6.3 Outline of Production Sequence
An outline of production operation is shown below. Refer to Section 6.4 for details of pre-production
procedures.
Figure 6-2 Outline of Production Sequence
Pre-startup Inspection
[See 9.2.1]
Pre-production
[See 6.4]
If preset has been set beforehand For new preset
Preset No. Selection
[See 6.5.1]
Weighing Parameter Setting
[See 5.6.1]
Production Start
[See 6.5.2]
Production Stop
[See 6.5.2]
End Production
[See 6.6]
If product is changed