DACS-W Operation Manual 1 SAFETY
1-5
1.4 Special Safety Precautions
This section describes special safety precautions for this equipment which, in addition to the previously
mentioned precautions, should be carefully observed.
• Before cleaning the equipment, shut off and lock the main power switch.
The person performing the cleaning should keep the key in his possession while cleaning.
• Install this equipment in a location fulfilling the following conditions:
Ambient temperature range: 0-40 °C
Ambient Humidity: 35-85 % (no condensation)
A hard horizontal surface with minimum vibration
• Do not use the same power source for devices which may emit noise. Doing so may result in
malfunction or damage.
• Do not place near wireless or other equipment emitting electronic waves. This may result in
malfunction or damage.
• Do not install wiring which permits load-related power fluctuations of more than ±10%.
Overload may result in malfunction or damage.
• Before attempting to shift this equipment, contact the distributor where the equipment was purchased
or Ishida Service representative.
• Do not apply excessive load to the weigh hoppers. Doing so may damage the weigh mechanism.
• When cleaning, be sure to rinse only the areas indicated. Otherwise, damage or malfunction may
result.
For areas not indicated as washable, clean by wiping with a dry cloth.
• Do not apply insecticide or other foreign substances inside the main body, terminal boxes, motor
boxes, or other enclosed weigher compartments. Doing so may cause machine malfunction or
damage.
To Next Page
Loading...
Need help?
General