DACS-W Operation Manual 5 NORMAL OPERATIONS & FUNCTIONS
5-3
5.3 Operational Levels
Weigher Operation is divided into three access levels : the Operator Level, Site Engineer Level and
Installation Engineer Level.
Table 5-1 shows how these levels are distinguished.
A password is necessary to enter the Site Engineer and Installation Engineer Levels.
Section "5.4 Access Level Change" explains the procedure for changing access levels.
The upper levels include the levels below. Higher levels access an increased number of functional items.
Figure 5-1 shows the functional configuration of the Operator level.
Table 5-2 shows the functions of the items in the Operator level.
Figure 5-2 shows the functional configuration of the Site Engineer level.
Table 5-3 shows the functions of the items in the Site Engineer level.
Chapter "8 ADDITIONAL FUNCTIONS" describes Installation level operation and functions.
Access to operational levels above the Operator level are restricted by
passwords so that only authorized personnel will be able to operate those
functions. Please control password assignments so that the security of
registered data is maintained.
• The default password for the Site Engineer level is [1], and for the Installation Engineer level is [2].
Table 5-1 Operational Levels
Level User Functions Password
Operator Level Operator Accesses only the basic menu used to operate the
weigher for daily production.
Not required
Lower ↑
Upper ↓
Site Engineer Level System manager Accesses the menu to set production values and
tune the weigher performance.
Required
Installation
Engineer Level
Technical engineer Accesses the menu to set the weigher installation
values.
To Next Page
Loading...
Need help?
General