DACS-W Operation Manual 8 ADDITIONAL FUNCTIONS
8-7
8.3 Changing to the Installation Engineer Level
A password is required to access the Installation Engineer Level from the Operator or Site Engineer
Levels.
To enter this level follow the procedure shown below.
1. In the Production Standby menu, press .
The Setup Menu appears.
2. Press to align the cursor with "Access
Level Change".
3. Press .
The Access Level Change menu appears.
Figure 8-3 Setup Menu (Level 0)
Figure 8-4 Setup Menu (Level 1)
4. Enter the Level 2 password via the ten-key
pad.
The Level 2 Setup Menu appears and Access
Level Change is complete.
Figure 8-5 Access Level Change Menu
Figure 8-6 Setup Menu (Level 2)
SET
UP
ENTER
▼
SELECT
ITEM
[Setup Menu]
* Preset 2
* Access Level Change Level 0
[Setup Menu]
* Preset 2
* Access Level Change Level 1
* Statistics & Print Setting
[Access Level Change]
Enter password.
[Setup Menu]
* Preset 2
* Access Level Change Level 2
* Statistics & Print Setting
To Next Page
Loading...
Need help?
General