ISHIDA DACS-W - Pre-Production Procedure

6 PRODUCTION DACS-W Operation Manual
6-4
6.4 Pre-Production Procedure
Before starting production, perform the following procedure.
Weighing operations can begin when this procedure is completed.
•
••
• Before performing the pre-production, check the checklist described in 9.2.1.
•
••
• Power should be turned on 30 minutes prior to production start to stabilize the
weighing mechanism circuitry.
1. Turn on the main power switch.
The production start display appears.
The preset data check menu appears.
After a moment, the zero adjustment standby
menu appears.
Figure 6-3 Main Power Switch
2. Perform Zero Adjustment.
(See 5.5.1)
Figure 6-4 Zero Adjustment Standby Menu
MAIN POWER
SWITCH
Before starting operation, press
[ZERO] key to zero adjust.