ISHIDA DACS-W - Page 66

5 NORMAL OPERATIONS & FUNCTIONS DACS-W Operation Manual
5-24
1. Call up the Preset menu.
2. Press to scroll the cursor to "Dynamic
Calibration".
3. Press .
The Dynamic Calibration standby menu
appears.
4. Place product on the weigh conveyor.
5. Press .
The Dynamic Calibration menu (1) appears.
6. Press to stop the Dynamic Calibration.
When static weighing calculation is
completed, the Dynamic Calibration menu (2)
appears.
Figure 5-51 Preset Menu
Figure 5-52 Dynamic Calibration Standby Menu
Figure 5-53 Dynamic Calibration Menu (1)
ENTER

▼

SELECT
ITEM
ENTER

▼

EXIT
[Preset]
No. 2
* Metal Detection Metal
* Preset Tare 10.0 g
* Dynamic Calibration
[Dynamic Calibration]
Place product on
weigh conveyor
then press [Enter] key.
[Dynamic Calibration]
Static weighing in progress:
Please wait.