Section 2: General operation Series 2280 Precision DC Power Supply Reference Manual
2-92 077085503 / March 2019
Measurement reset values
Default value reset from
MENU > System > Settings
> Reset
Default value reset by the
*RST (on page 7-7)
command or
:SYSTem:PRESet (on
page 7-124) command
MENU > Measure > Settings > Function
:SENSe[n]:FUNCtion (on page 7-60)
MENU > Measure > Settings > Range and
HOME > Range
:SENSe[n]:<function>:RANGe (on page 7-
67)
Concurrent: Auto (10 mA)
Current: Auto (10 mA)
Voltage: 20 V
Concurrent: 0.0100
Current: 0.0100
Voltage: 20.0000
MENU > Measure > Settings > Range
HOME > Range
:SENSe[n]:<function>:RANGe:AUTO (on
page 7-69)
Concurrent: On
Current: On
Voltage: Off
Concurrent: 1 (On)
Current: 1 (On)
Voltage: Not applicable
MENU > Measure > Settings > Digits
:SENSe[n]:<function>:DIGits (on page 7-65)
MENU > Measure > Settings > NPLC
:SENSe[n]:<function>:NPLCycles (on page
7-66)
MENU > Measure > Settings > Auto Zero
:SYSTem:AZERo[n][:STATe] (on page 7-
111)
HOME > Resolution
:SENSe[n]:<function>:RESolution (on page
7-73)
MENU > Measure > Rel/Filter > Type
:SENSe[n]:<function>:AVERage:TCONtrol
(on page 7-63)
MENU > Measure > Rel/Filter > Count
:SENSe[n]:<function>:AVERage:COUNt (on
page 7-61)
MENU > Measure > Rel/Filter > Window
:SENSe[n]:<function>:AVERage:WINDow
(on page 7-64)
MENU > Measure >Rel/Filter > Filter State
:SENSe[n]:<function>:AVERage[:STATe]
(on page 7-62)
MENU > Measure > Rel/Filter > Reference
:SENSe[n]:<function>:REFerence
MENU >Measure > Rel/Filter > Rel State
:SENSe[n]:<function>:REFerence:STATe
(on page 7-72)
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed
here on the menu, it may not be available for the function you are using.