Keithley 2280 Series - Page 112

Series 2280 Precision DC Power Supply Reference Manual Section 2: General operation
077085503 / March 2019 2-93
Source reset values
Setting*
Default value reset from
MENU > System >
Settings > Reset
Default value reset by the
*RST (on page 7-7)
command or
:SYSTem:PRESet (on page
7-124) command
MENU > Source > Settings> I-Limit
[:SOURce[n]]:<function>[:LEVel][:IMMediate][:AM
PLitude] (on page 7-77)
0.1000 A
0.1000
MENU > Source > Settings > V-Set
[:SOURce[n]]:<function>[:LEVel][:IMMediate][:AM
PLitude]
0.000 V
0.0
MENU > Source > Settings > Slew Rise
[:SOURce[n]]:VOLTage:SLEW:RISing (on page 7-
79)
100.0 V/s
100.0000
MENU > Source > Settings > Slew Fall
[:SOURce[n]]:VOLTage:SLEW:FALLing (on page
7-80)
100.0 V/s
100.0000
MENU > Source > Protect > Overcurrent
Protection
[:SOURce[n]]:<function>:PROTection[:LEVel] (on
page 7-76)
6.10 A
6.10
MENU > Source > Protect > Overvoltage
Protection
[:SOURce[n]]:<function>:PROTection[:LEVel] (on
page 7-76)
21.0 V
21.0
MENU > Source > Protect > Maximum Voltage
[:SOURce[n]]:VOLTage:LIMit[:AMPLitude]
20.000 V
20.000
MENU > Source > Delay > Source Delay
[:SOURce[n]]:DELay (on page 7-74)
0.00100 s
0.00100
MENU > Source > Delay > State
[:SOURce[n]]:DELay:STATe (on page 7-75)
Off
0 (Off)
HOME > List > Mode
[:SOURce[n]]:LIST:MCOMPlete (on page 7-86)
Sweep
SWEEP
HOME > List > Enable
[:SOURce[n]]:LIST:STATe (on page 7-91)
Off
0 (Off)
HOME > List > Hold Time
[:SOURce[n]]:LIST:HTIMe (on page 7-84)
Point
POINT
HOME > List > End Zero
[:SOURce[n]]:LIST:END:ZERO (on page 7-84)
Off
0 (Off)
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed here on
the menu, it may not be available for the function you are using.