2MN/2N1-1
1-3-113
U332 Setting the size conversion factor
Description
Rate: Sets the coefficient of nonstandard sizes in relation to the A4/Letter size. The coefficient
set here is used to convert the black ratio in relation to the A4/Letter size and to print the service
status page.
Mode: Make settings on the color print coverage counter displays, as well as the coverage
threshold.
Method
1. Press the OK key.
2. Select the item to set.
Setting: [Rate]
Purpose: To set the coefficient for converting the black ratio for nonstandard sizes in relation to
the A4/Letter size.
1. Change the setting using the numeric keys.
2. Press the OK key. The value is set.
Setting: [Mode]
Purpose: Make settings on the color print color/coverage counter displays.
1. Select the mode.
Initial setting: 0
* : If ‘0’ has been changed to ‘1’, revert the U260 feed/eject counter switch to its initial state
(Eject).
2. Press the OK key. The setting is set.
Setting: [Level 1/2]
Purpose:Make settings on the color print coverage threshold.
1. Select the item.
2. Change the setting using the numeric keys.
3. Press the OK key. The value is set.
Completion
Press the Back key. The screen for selecting a maintenance item No. is displayed.
Item No. Description
Display Description
Rate Size coefficient
Mode Toggling full-color count and color coverage count display
Level 1 Low coverage threshold value
Level 2 Middle coverage threshold value
Display Description Setting range Initial setting
Rate Size coefficient 0.1 to 3.0 1.0
Display Description
0 Full-color count display
1 Color coverage count display
Display Description Setting range Initial setting
Level 1 Low coverage threshold value 0.1 to 99.8 1.0
Level 2 Middle coverage threshold value 0.1 to 99.9 2.5
To Next Page
Loading...
Need help?
General