Kyocera ECOSYS FS-C8650DN Service Manual

2MN/2N1
1-3-83
U161 Setting the fuser control temperature
Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper,
or solve a fuser problem on thick paper.
Method
1. Press the OK key.
2. Select the item to be set.
Setting: [WarmUp]
1. Select the item to be set.
2. Change the setting value using the numeric keys.
3. Press the OK key. The value is set.
Item No. Description
Display Description
WarmUp Control temperature except at printing
Print Control temperature during printing
LowPower Mode Heating power reduction control
Grain Mode Setting the grain mode
Display Description
Setting
range
Initial setting
45ppm 55ppm
Ready
(C)
Control temperature at dis-
playing Ready (Center)
130 to 200
(°C)
165 170
Ready
(E)
Control temperature at dis-
playing Ready (Edge)
100 to 200
(°C)
140 145
Ready
(P)
Control temperature at dis-
playing Ready (Press)
0 to 200
(°C)
80 80
Drive
(C)
Stable temperature during
driving (Center)
130 to 200
(°C)
170 175
Wait
(C)
Stable temperature during
halt (Center)
130 to 200
(°C)
165 175
Low Power
(P)
Control temperature at low
power consumption
(Press)
0 to 200
(°C)
150 150
F.S. Shift(C Full speed shift tempera-
ture (Center)
0 to 200
(°C)
50 50
Pressure(P) Pressurizing beginning
temperature (Press)
0 to 200
(°C)
155 160

Kyocera ECOSYS FS-C8650DN Specifications

General

Brand	Kyocera
Model	ECOSYS FS-C8650DN
Category	Printer
Language	English