2MN/2N1
1-4-85
1-4-3 Image formation problems
If the part causing the problem was not supplied, use the unit including the part for replacement.
(1) No image
appears (entirely
white).
(2) No image
appears (entirely
black).
(3) Image is too
light.
(4) The back-
ground is col-
ored.
(5) White streaks
are printed verti-
cally.
See page 1-4-86 See page 1-4-86 See page 1-4-87 See page 1-4-87 See page 1-4-88
(6) Black streaks
are printed verti-
cally.
(7) Streaks are
printed horizon-
tally.
(8) Spots are
printed.
(9) Image is
blurred.
See page 1-4-88 See page 1-4-88 See page 1-4-89 See page 1-4-89
(10)The leading
edge of the
image is con-
sistently mis-
aligned with the
original.
(11) The leading
edge of the
image is spo-
radically mis-
aligned with the
original.
(12)Paper is wrin-
kled.
(13)Offset occurs. (14)Part of image is
missing.
See page 1-4-89 See page 1-4-89 See page See page 1-4-90 See page 1-4-90
(15)Fusing is loose. (16)Image is out of
focus.
(17)Image center
does not align
with the original
center.
(18)Unevenly repeat-
ing horizontal
streaks in the
printed objects.
(19)Colored spots
in the printed
objects.
See page 1-4-91 See page 1-4-91 See page 1-4-91 See page 1-4-91 See page 1-4-91
To Next Page
Need help?
General