2MN/2N1-1
1-3-6
Developer U157 Checking the developer drive time -
U158 Checking the developer count -
Fuser U161 Setting the fuser control temperature
Warm Up 165/140/80/170/165/
150/50/155
170/145/80/175/175/
150/50/160
Print 170/5 175/5
Low Power Mode Mode1
Grain Mode Mode0
U167 Checking/clearing the fuser count -
U169 Checking/setting the fuser power source -
U199 Displaying fuser heater temperature -
Operation
panel and
support
equip-
ment
U207 Checking the operation panel keys -
U208 Setting the paper size for the side deck Letter (Inch)/A4 (Metric)
U221 Setting the USB host lock function Off
U223 Operation panel lock Unlock
U234 Setting punch destination Inch (Inch)/Europe Metric (Metric)
U237 Setting finisher stack quantity 0/0
U240 Checking the operation of the finisher -
U241 Checking the operation of the switches
of the finisher
-
U246 Setting the finisher
Finisher 0/0/0/0/0/0/0/0
Booklet 0/0/0/0/0/0/0/0/0
U247 Setting the paper feed device -
Mode
setting
U250 Checking/clearing the maintenance
cycle
600000/600000/300000
U251 Checking/clearing the maintenance
counter
0/0/0
U252 Setting the destination -
U253 Switching between double and single
counts
DBL(A3/Ledger)
U260 Selecting the timing for print counting Eject
U265 Setting OEM purchaser code -
U271 Setting the page count 2/3
U278 Setting the delivery date -
U285 Setting service status page On
Section
Item
No.
Content of maintenance item
Initial setting
45ppm 55ppm
To Next Page
Loading...
Need help?
General