Lexmark C792e 5062-210 - 938.19-Waste Toner Full Sensor Error Service Check

Diagnostic information 2-105
5062
938.19—Waste toner full sensor error service check
Step Questions / actions Yes No
1 Turn the printer off, and open the system
board shield. Check the cable in connector
JWTBF1 for proper connection to the system
board.
Is the cable properly connected?
Go to step 2. Reseat the cable.
2
Check the cable for damage.
Is the cable damaged?
Replace the waste toner
cable. See “Waste toner
full cable removal” on
page 4-150.
Go to step 3.
3
Remove the waste toner full sensor. See
“Waste toner full sensor removal” on
page 4-151.
Check the cable connected to the sensor.
Is the cable properly connected?
Go to step 4. Reseat the cable.
4
Replace the waste toner full sensor. See
“Waste toner full sensor removal” on
page 4-151.
Does the error reoccur?
Replace the system board.
See “System board
removal” on page 4-142.
Problem solved.