Lexmark C792e 5062-210 - Finisher or Stacker Sensor (Paddle HP) Removal; Finisher Sensor (Stapler Access Door Interlock) Removal

Repair information 4-261
5062
Finisher or stacker sensor (paddle HP) removal
See “Finisher assembly (continued)” on page 7-25 for the part number.
1. Remove the option from the printer.
2. Remove the paddle drive motor. See “Finisher or stacker paddle drive motor assembly removal” on
page 4-255.
3. Disconnect the cable from the sensor.
4. Press the tabs to remove the sensor.
Finisher sensor (stapler access door interlock) removal
1. Remove the finisher from the printer.
2. Remove the finisher rear cover. See “Finisher or stacker rear cover removal” on page 4-257.
3. Disconnect the cable from the sensor.
4. Pinch tab (A) to remove the sensor.