Dismantle the 2 bolts after securing the sliding pin of the slave cylinder of the rear disc brake. ②
See Fig. 2-62.
Fig. 2-62
4) Dismantle the rear brake pad suite.
Dismantle the brake pad with 2 silencer pads.①
Dismantle No. 1 and No. 2 silence pad from each brake pad.②
5) Dismantle the rear brake pad holding piece. Remove the 2 friction pads from the support of the
brake master pump.
6) Remove the sliding pin of the slave cylinder of the rear disc brake. Remove the sliding pin from
the support of the disc brake master pump.
7) Dismantle the dustproof cover of the rear brake sliding pin. Remove the 2 dustproof covers from
the support of the rear disc brake slave cylinder. See Fig. 2-63.
Fig. 2-63
8) Dismantle the left rear disc brake slave cylinder support. Remove the 2 bolts and then take off
the support.
9) Dismantle the dustproof cover of the brake slave cylinder. Remove the fixing ring and dustproof
cover by a screwdriver. See Fig. 2-64.
Fig. 2-64
To Next Page
Loading...
